Exqutoo 2Pack 4-Pin Waterproof DT Connector Male and Female Wire Connectors with 16AWG 105℃ 600V Wires and Heat Shrink Tubes, Applicable for Automotive Electrical Connections

Good quality multi-pin weathertight connector. I used this on my truck topper as a disconnect between my truck and the topper (for easier topper removal). There are plenty of circuits available to run systems like third brake light, dome light, and power locks (if you have the setup). Overall, well worth the money.

Very good set of connectors. Good quality.

Good quality! Worked well for my DC application.

Easy to use, well made and waterproof. Perfect for automotive projects.

The product was as expected and of good quality.

When I purchased the Exqutoo 2Pack 12-Pin Waterproof DT Connector Male and Female Wire Connectors, I had a very specific application in mind. Since these multi-pin connectors are generally used in automotive, underhood applications, I figured they would be perfect for use on my domestic hot water boiler electrical system. As it turns out, most domestic boilers have a relatively complicated computer for control of ignition, flame verification, and temperature maintenance. The trouble is, at least in my application, the boiler sits in a small, exterior "closet" on the outside of the residence. Because of the location, the temperature within the enclosure can vary significantly. This has resulted in many of the spade connectors tying the system together to loosen and occasionally being unable to transmit micro-voltage signals to, or from, the computer controller. This causes the computer to go into "lock-down" mode resulting in no heat. Imagine that happening on a cold and wintry morning when you are in a rush to get to work. No heat or hot water, for that matter. What a perfect application for a waterproof, multi-pin connector that bundles all of the control wires together into a neat, heat-resistant, waterproof system. The terminal wire ends are all soldered into the computer and component terminals and the multi-pin system allows for easy servicing or replacement of components. Sure wish the boiler manufacturer had thought of this when I purchased the system.

The connector head m/f are bulky for the amount of connections, but sturdier then a German Woman holding 8 Beers in a Texas Storm.

Did exactly what I needed it to do. Has been holding up well exposed to the elements as well.